• Elastic potential energy is defined as

The energy stored within a material (e.g. in a spring) when it is stretched or compressed

• It can be found from the?area under the force-extension graph?for a material deformed within its limit of proportionality
  • A material?within its limit of proportionality?obeys Hooke’s law
• Therefore, for a material obeying Hooke’s Law, elastic potential energy can be calculated using:

• Where:
  • k?= force constant of the spring (N m^–1)
  • x?= extension (m)
• In your data booklet the extension?x?is written as?Δx?
  • This just means the change in?x

• It is very dangerous if a wire under large stress suddenly breaks
• This is because the elastic potential energy of the strained wire is converted into kinetic energy

EPE = KE

??kx²?= ??mv²

v?∝?x

• This equation shows that the greater the extension of a wire,?x, the greater the speed,?v, it will have on breaking

Step 1: List the known values

• • Force constant,?k?= 50 kN m^–1?= 50 × 10³?N m^–1
  • Compression,?x?= 10 cm = 10 × 10^–2?m

Step 2: Write the relevant equation

EPE = ??kx²

Step 3: Substitute in the values

EPE = ? × (50 × 10³) × (10 × 10^–2)²?=?250 J

Force–Extension graphs

• Work has to be done to stretch a material
• Before a material reaches its?elastic limit?(whilst it obeys Hooke's Law), all the work is done is stored as?elastic potential energy (EPE)
• The work done, or the elastic potential energy is the?area under the force-extension graph

Work done is the area under the force-extension graph

• This is true for whether the material obeys Hooke’s law or not
  • For the region where the material?obeys?Hooke’s law, the work done is the area of a?right-angled triangle?under the graph
  • For the region where the material?doesn’t obey?Hooke’s law, the area is the?full region?under the graph. To calculate this area, split the graph into separate segments and add up the individual areas of each

Breaking Stress

• As greater force is applied on a material, the?stress?on it increases
• The breaking stress is the?maximum stress a material can stand before it fractures (breaks)
  • A material with high breaking stress is considered?ductile, which means it can extend more before breaking because of?plastic?deformation
  • A common example of this is copper, as well as being a good electrical conductor, copper is ductile so it is a suitable material for making wires
• The ultimate tensile stress (UTS) is sometimes also marked on a stress-strain graph
  • This is the?maximum stress that the material can withstand
• The UTS and breaking stress can depend on the condition of the material such as its temperature
  • This is very important for engineers when considering materials for a particular structure
  • The material might need to stand extreme temperatures and loads which are taken into consideration

The ultimate breaking stress is the point on the stress-strain graph of maximum stress. The breaking point is where the material fractures