• Neurones?transmit information in the form of?impulses, which travel extremely quickly along the neurone from one end to the other
  • Note that an impulse is?not?an electrical current that flows along neurones as if they were wires
  • Instead, an impulse is a?momentary reversal in the electrical potential difference?across the?neurone cell surface membrane
    • The electrical potential difference across a membrane can also be described as the?voltage?across a membrane, the?difference in charge?across a membrane, or the?membrane potential
• In an axon?that is?not transmitting an impulse?the?inside?of the axon always has a?negative electrical potential, or charge, compared to?outside?the axon, which has a?positive electrical potential
  • This membrane potential in a resting neurone is known as?resting potential
• The?resting potential?is usually about?-70 millivolts (mV)
  • This means that the?inside?of the resting axon has a?more negative?electrical charge than the?outside?by about?70 mV
• Two main processes contribute to establishing and maintaining resting potential:
  • The?active transport?of sodium ions and potassium ions
  • A difference in rates of diffusion of sodium ions and potassium ions
• In addition to these two main processes,?negatively charged proteins?inside the axon also contribute to the negative resting potential

The?active transport of sodium ions and potassium ions

• Carrier proteins called sodium-potassium pumps are present in the cell surface membranes of neurones
• These pumps use?ATP?to actively transport?sodium ions?(Na?)?out?of the axon and?potassium ions?(K?)?into?the axon
• The two types of ion are pumped at an unequal rate; for every?3 sodium ions that are pumped out?of the axon, only?2 potassium ions are pumped in
• This creates a?concentration gradient?across the membrane for both sodium ions and potassium ions

Difference in rates of diffusion of sodium ions and potassium ions

• Because of the concentration gradient generated by the?sodium-potassium pumps, both sodium and potassium ions will diffuse back across the membrane
  • The neurone cell surface membrane has?sodium ion channels?and?potassium ion channels?that allow sodium and potassium ions to move across the membrane by?facilitated diffusion
• The neurone membrane is much?less permeable?to sodium ions than potassium ions, so potassium ions inside the neurone can diffuse?out?at a?faster rate?than?sodium ions?can diffuse?back in
• This results in?far more positive ions?on the?outside?of the neurone than on the inside, generating a?negative charge?inside?the neurone in relation to the outside
• The result of this is that the neurone has a?resting membrane potential?of around?-70 millivolts (mV)

Sodium-potassium pumps in the membrane of a resting neurone generate a concentration gradient for both sodium ions and potassium ions. This process, together with the facilitated diffusion of potassium ions back out of the cell at a faster rate than sodium ions diffuse back into the cell, generates a negative resting potential across the membrane.?

• Once resting potential is reached, the neurone membrane is said to be?polarised
• To initiate a nerve impulse in a neurone, the neurone membrane needs to be?depolarised
  • Depolarisation is the?reversal of the electrical potential difference?across the membrane
• The depolarisation of the membrane occurs when an?action potential?is generated
  • Action potentials lead to the reversal of resting potential from around?-70 mV?to around?+40 mV?
• Action potentials involve the?rapid movement?of?sodium ions?and?potassium ions?across the?membrane?of the?axon
• An action potential is the?potential electrical difference?produced across the axon membrane when a neurone is?stimulated?e.g. when an environmental stimulus is detected by a receptor cell

How an action potential is produced

• Some of the ion channels in the membrane of a neurone are?voltage gated, meaning that they open and close in response to changes in the?electrical potential?across the membrane
  • Voltage gated ion channels are?closed?when the membrane is at rest, but they are involved in the generation and transmission of action potentials
  • Note that not all of the channels in a neurone membrane are voltage gated e.g. some types of potassium ion channel are open when a neurone is at rest to enable potassium ions to diffuse out of the axon and generate resting potential
• When a neurone is stimulated, the following steps occur:
  • A small number of?sodium ion channels?in the axon membrane?open
  • Sodium ions?begin to move?into the axon?down their?concentration?gradient
    • There is a greater concentration of sodium ions outside the axon than inside due to the action of sodium-potassium pumps
  • This?reduces?the?potential difference?across the axon membrane as the?inside?of the axon becomes?less negative
  • If enough sodium ions enter the axon and the potential difference is reduced enough,?voltage gated sodium ion channels?open, leading to a further, large influx of sodium ions
  • Once the charge has been reversed from -70 mV to around +40 mV,?an action potential?is said to have been?generated

How an action potential is propagated

• Once an action potential has been generated, it can be?propagated, or transmitted, along the length of the axon
  • The depolarisation of the membrane at the site of the first action potential causes?sodium ions?to diffuse along the cytoplasm into the next section of the axon,?depolarising?the membrane in this new section, and causing voltage gated sodium channels to open
  • This triggers?another action potential?in this section of the axon membrane
  • This process then repeats along the length of the axon
• In the body, this allows action potentials to begin at one end of an axon and then pass along the entire length of the axon membrane

How an impulse is propagated in one direction along the axon of a neurone

Repolarisation

• About 1 ms after an action potential is generated, all the?voltage gated sodium channels?in this section of membrane?close
• Voltage gated potassium channels?in this section of axon membrane now?open, allowing the diffusion of potassium ions?out of the axon, down their concentration gradient
  • Remember that the sodium-potassium pumps have not stopped working during the action potential; hence the potassium ion gradient is still present
• This movement of potassium ions causes the inside of the axon to become negatively charged again, a process known as?repolarisation
  • There is a short period during which the membrane potential is more negative than resting potential; this is known as?hyperpolarisation
  • The period during which the membrane is hyperpolarised is known as the?refractory period
    • The membrane is unresponsive to stimulation during the refractory period, so a new action potential cannot be generated at this time
    • This makes the action potentials?discrete?events and means the impulse can?only?travel in one direction
    • This is essential for the successful and efficient transmission of nerve impulses along neurones
• The voltage gated potassium channels then?close,?and the?sodium-potassium pumps?work to restore?resting potential
  • Only once resting potential is restored can the membrane be stimulated again

The depolarisation and repolarisation of an action potential can be clearly seen in a graph of membrane potential against time

• An?action potential?is only?initiated?if the?threshold potential?is reached
• When a neurone is stimulated, sodium ion channels in the axon membrane open and sodium ions pass into the axon down their concentration gradient
• This causes the inside of the axon to become?less negative,?but exactly how much less negative it becomes is dependent on the number of sodium ion channels that open
  • A large stimulus will cause more channels to open than a small stimulus
  • If more channels open, then more sodium ions will enter the axon, causing it to become less negative
• If the potential difference reaches around?-50 mV,?known as the?threshold potential, voltage gated sodium ion channels open and?many more?sodium ions enter the axon
  • This causes the membrane potential to reach around +40 mV
• Once the charge has been reversed from -70 mV to +40 mV, an action potential is generated

The all-or-nothing principle

• Action potentials are either generated or not generated depending on whether the threshold potential is reached; there is?no such thing as a small or large action potential
  • If a stimulus is?weak,?only a few sodium ion channels will open and the membrane won’t be sufficiently depolarised to reach the?threshold potential;?an action potential will not be generated
  • If a stimulus is?strong enough?to raise the membrane potential above the?threshold?potential?then an action potential will be generated
• This is the?all-or-nothing principle
  • An impulse is?only transmitted?if the?initial stimulus is sufficient?to increase the membrane potential above a?threshold potential
• Stimulus size can be detected by the brain because as the?intensity of a stimulus?increases, the?frequency?of action potentials transmitted along the neurone?increases
  • This means that a small stimulus may only lead to one action potential, while a large stimulus may lead to several action potentials in a row

As the strength of a stimulus increases beyond the threshold potential, the frequency of action potentials increases

• The propagation of nerve impulses along axons occurs due to?local currents?that cause each successive section of the axon to reach the?threshold potential
• Inside?the?depolarised?section of the axon
  • There is a?high concentration?of sodium ions due to their recent?influx
  • This creates a?concentration gradient?between the section of the axon that has depolarised and the section next to it
  • Sodium ions diffuse along?inside?the axon to the neighbouring section of axon that has not yet become depolarised
  • This reduces the negative membrane potential in the new section of axon and, if a threshold is reached, begins the initiation of an action potential
    • This enables the original action potential to be propagated
• On the?outside?of the axon
  • There is a higher concentration of sodium ions outside the section of axon that has?not yet become depolarised?due to the diffusion of sodium ions?into the depolarised section
  • Sodium ions diffuse from here along the outside of the axon to the section of axon that has just become depolarised
• These movements of sodium ions are known as?local currents
• These local currents cause a?wave of depolarisation?and?repolarisation?to travel along the axon, resulting in the?propagation of a nerve impulse

The propagation of nerve impulses along axons occurs due to local currents created by the diffusion of sodium ions